average temperature difference

英 [ˈævərɪdʒ ˈtemprətʃə(r) ˈdɪfrəns] 美 [ˈævərɪdʒ ˈtemprətʃər ˈdɪfrəns]

网络  平均温差

机械



双语例句

  1. The dimensionless average temperature and dimensionless temperature difference of rotor surface decrease with both of the dimensionless mass flow rate and rotational Reynolds number are increased.
    随着旋转雷诺数和进气流量系数增加,转盘无量纲过余表面平均温度和无量纲径向表面温差全都下降。
  2. The evolution of the structure of water cooling for dry drawing reel is elaborated using fluid mechanics theory and conduction theory. It is indicated that raising heat conducting coefficient and average value of temperature difference, and enlarging conducting area can strengthen water cooling results of reel.
    运用流体力学理论及传热理论,对干式拉丝机卷筒水冷结构的发展进行阐述,指出提高传热系数,增加传热面积,增大温差平均值可强化卷筒水冷效果。
  3. Also, the numerical and experimental results of the interface height, average temperature rise of each room and the pressure difference between the two rooms near the ceiling are presented.
    同时还给出了所算例子各房间界面高度、平均温升及两房间在顶篷附近压差的计算值与实验值。
  4. Analyses on average temperature difference resulted from different calculation methods
    不同方法计算的气温平均值差异分析
  5. The fruit acid and vitamin C are positively related with altitude, but negatively related with annual average temperature and the difference is very significant ( P < 0 01).
    含酸量、Vc与海拔高度呈正相关,与年平均气温呈负相关,差异极显著(P<001)。
  6. According to the arch dam design criterion in our country, the thermal loading in arch dams includes the average temperature and the equivalent linear temperature difference in dam cross-section, the influence of non linear temperature difference is excluded.
    按照我国现行拱坝设计规范规定,拱坝温度荷载仅考虑运行期坝体断面平均温度和等效线性温差,不考虑非线性温差的影响。
  7. The average temperature difference between air and soil surface was 2.0 ℃ during growing season of crops ( from March to October);
    农作物生长季(3~10月)平均地气温差为20℃,年平均地气温差09℃;
  8. Combined with the total quantity of heat exchanging and the average logarithmic temperature difference which are gained by numerical simulation before, the heat transfer area can be calculated.
    结构方面,通过热力计算得出总换热系数,结合之前通过数值模拟得到的换热量与平均对数温差,计算出了换热面积。
  9. Two degrees of freedom are employed for node of element: average temperature and difference temperature.
    单元每个节点包含两个自由度:厚度方向的平均温度和温差。